How To Attach the highs to the belt.

In a time when elastic didn't exist, garter belts were invented as a way to hold up stockings.They're mostly used as a fashion accessory, adding a bit of flair to your undergarments.They can be a bit difficult to put on if you wear them all day.Pick the right belt for your purpose to make them easier to wear.

Step 1: The garter needs to be put on.

The garters may slip on.Most will have a hook and clasp system.Wrap it around your waist.The back is where the closure usually goes.It is comfortable if you adjust it so it stays up.The belt should be wrapped around your waist.It should be placed at your waist.Attach it by sliding the hooks into the clasps.The most comfortable line of clasps is what you choose.This step is similar to attaching a bra.If you have trouble attaching it in the back, you can move it to the front.

Step 2: Put your pantyhose on.

Pull up your thigh highs.The straps need to be adjusted to meet the top of the hose.You want your straps to be different lengths.The ones in the back should be the longest.The straps on the sides should be an inch shorter and the front two inches shorter than the back, all of which will help you bend easier.When you sit down, it helps.

Step 3: Attach the clasps to your thigh highs.

The rubber nub and metal piece fit over the clasp.The rubber nub should be underneath the top edge of the stocking.Unless it's sewn on at an angle, the clasp should reach straight down to the stocking.It should fall close to the top of the stocking.The metal clasp should be over the nub.Pull the nub into place.Continue with the clasps around the belt.To see the rubber nub sticking out through the front, push it from behind.Don't push so hard that you tear a hole in your stockings.There are two narrow ends at the bottom of each clasp.Pull up the narrow end and slide it over the nub to hold it in place.If you have plastic clasps, be careful.The plastic clasp will snap in two if you apply too much pressure.

Step 4: As needed.

Once you get your stockings settled, you'll need to adjust them to make sure they're at the right height.You will probably need to adjust throughout the day.You can check on them when you're in the bathroom.If you want to see how it fits, you need to sit down and stand up with the belt on.You don't want it to be too tense when you sit down.When you stand up, your thigh highs should be mostly taut, as you don't want them pooling at your ankle.As needed, loosen and tighten the straps.

Step 5: The last thing to do is put on your underwear.

It may seem counter-intuitive.You should put a belt on the outside of your undergarments.If you want to use the bathroom more quickly.If you put your panties on before the belt, you'll have to remove the straps, take off your belt and use the restroom.It's a problem if you put your underwear over the belt.It's fine to put your underwear on first if you're only going to wear the belt for a short time.If you plan to wear it all day, you might want to put your underwear under your skirt or pants.If you prefer, you can go without underwear.

Step 6: Find the correct size.

A one-size-fits-all model is what a garter belt may be.It won't fit everyone, but it may fit some people.Many brands make them in standard sizes, so finding one that is in your size is a better bet.Some stores may not allow you to try it first.A belt that stays in place is what you want.Your thigh highs will slip if it slips.You don't want one that's too tight.It should be loose enough to be comfortable.Finally, look for one that can be adjusted.The hooks are similar to a bra and you can make adjustments as needed.

Step 7: Pick one that has metal clasps.

Plastic clasps do not hold as well as metal.The plastic ones tend to break.Pick a belt that has metal clasps for the best grip.

Step 8: The best straps can be found.

For the best hold, pick a belt that has 6 clasps.If you plan on wearing it for more than an hour, some may have only four.It's important to look for elastic straps.When you bend over or move around, elastic will allow the straps to keep hold of your thigh highs, as it means they have give and won't pop off at the clasp.You can find many more straps, up to 8 or 10, which will hold even better.Thick straps provide a better hold and are less likely to twist.

Step 9: How much coverage do you want?

A small belt is formed across your waist by some garter belts.Others are much bigger.It's up to you.Garter belts are often used as lingerie and you should base it on how comfortable it is.If you plan to wear it all day, a wider belt will be more comfortable.

Step 10: Pick a fabric that's practical.

The fur belt is not going to be comfortable or breathe well.If you're only planning on wearing the belt for a short time, that's fine.If you plan to wear it all day, choose something that will breathe better and give you more comfort.

Step 11: Determine how much you want to spend.

Cheap belts seem to be a great option, but they probably won't hold up.If you're going to wear it a lot, you might want to spend more money to get a better belt.

Related Posts:

  1. How To Attach Thigh Highs to a Garter Belt
  2. What is the difference between nylons and stockings?
  3. How To Select a Garter Belt
  4. There is a Garter Belt.