The finish on brushed nickel can make cleaning difficult.The gentlest way to clean brushed nickel is by using it.Don't use alcohol, acid, or solvent-based cleaners on brushed nickel.The finish can be damaged.If other methods haven't worked, you can use vinegar to get rid of stubborn mineral deposits.It's best to test an area first.
Step 1: Use a soft, dry cloth to wipe.
There is a clean, lint-free cloth.Terry cloth works well, but soft cotton can be equally useful.Dust, smudges, and grease can be removed.Use small motions.Remove the shade before you clean it.
Step 2: Use a damp cloth and a knife.
Wet a cloth.The cloth should be pressed onto the area.Carefully remove the gunk only, not the nickel itself.Use a soft, dry cloth to buff the area.
Step 3: You can use a mild soap solution.
A soft, clean cloth can be washed with a squirt of detergent.Use the wet cloth to wipe your nickel item.It can be washed or sponged with water.It needs to be dry thoroughly.It cuts grease while remaining gentle, so washing soap is effective.The simpler the soap is, the better.Additives in scented soaps create more streaking rather than removing it.
Step 4: Determine if the wax is compatible with your product.
If you still have the product's instruction manual, check it out.You can look at the FAQ section on the brand's website.If you can't determine your product's compatibility with wax, try calling the company.Some brands use wax paste to polish their products.Others advise against it.It is possible to restore its sheen with polishing brushed nickel.
Step 5: Put wax paste on.
It is possible to use a very light polish.Put a thin layer of wax over the item.Allow it to sit for a while.At hardware or automotive stores, you can find this type of polish.
Step 6: Rub the wax off.
Remove the wax with a soft cloth.Use circular motions to clean your product.You don't want to leave wax on the nickel if you move to a new area.
Step 7: White vinegar should beDiluted with water.
You can make a solution with half water and half white vinegar.If you have a shower head, make enough solution to completely soak it.To save time, use a container that will fit in the microwave.
Step 8: A concealed area is being tested.
Put the solution in a container.There is a cotton swab in the solution.There is a hard-to-see area for your nickel product.Allow it to sit for 30 minutes.If there is no visible damage to the brushed nickel finish, you can proceed to clean the entire item.
Step 9: Warm up the solution.
Use a microwave-safe container to heat the solution.You can heat the solution on the stove top.The solution should only be heated until it is warm.
Step 10: You can spray or soak it.
Allow the nickel piece to sit for 30 minutes if it is small enough.Pour the solution into a spray bottle and use the brushed nickel to remove the nickel piece.Allow the solution to sit for 30 minutes.
Step 11: Remove the mineral deposits.
If applicable, remove the item from the solution.The mineral deposits should be wiped off with a rag.If that doesn't work, you can use a toothbrush or soaked cotton wool.If you have a shower nozzle, use a paperclip to get rid of the jet holes.If there are still mineral deposits to be found, repeat the application of the diluted vinegar.
Step 12: It's a good idea to rinse your item.
Don't leave it on the product's surface.To thoroughly wash the brushed nickel, use a bucket of water or a rag.To avoid water stains, buff dry with a soft cloth.