- Connect a laptop or a desktop PC to the console port on the front panel of the device.
- Power on the device and wait for it to boot. ...
- Log in as the user root . ...
- Type cli to start the Junos OS CLI. ...
- Type configure to access CLI configuration mode.
How do I assign an IP address to a Juniper switch?
- Use the command “family inet address” to configure a management IP address on the interface. set interfaces me0 unit 0 family inet address 10.93.15.246/21.
- Configure a static route with the next hop to the management network default gateway set routing-options static route 0.0.0.0/0 next-hop 10.93.15.1/21.
How do you set up a Juniper device?
- Connect to the device through the console port.
- Power on the device and wait for it to boot. ...
- Log in as the user root . ...
- Start the Junos OS command-line interface (CLI): ...
- Enter Junos OS configuration mode: ...
- Configure the hostname of the device.
How do I connect my juniper switch to my laptop?
- Connect the console port to a laptop or PC using the RJ-45 to DB-9 serial port adapter. ...
- At the shell prompt type ezsetup.
- Enter the hostname. ...
- Enter the root password. ...
- Enter yes to enable services like Telnet and SSH.
How do I get out of juniper config mode?
- To commit the configuration and exit: [edit] user@host# commit and-quit commit complete Exiting configuration mode user@host>
- To exit without committing: [edit] user@host# exit Exiting configuration mode user@host>
What is operational mode in Juniper?
Operational mode—Use this mode to display the current status of the device. In operational mode, you enter commands to monitor and to troubleshoot the network operating system, devices, and network connectivity. ... Junos OS stores a configuration as a hierarchy of configuration statements.
How do I assign a management IP to a switch?
- enter the VLAN 1 configuration mode with the interface vlan 1 global configuration command.
- assign an IP address with the ip address IP_ADDRESS SUBNET_MASK interface subcommand.
- enable the VLAN 1 interface with the no shutdown interface subcommand.
How do you set up a Juniper switch?
- Connect the console port to a laptop or PC using the RJ-45 to DB-9 serial port adapter. ...
- At the prompt type ezsetup.
- Enter the hostname.
- Enter the root password. ...
- Enter yes to enable services like telnet and SSH.
- Next, select one of the switch management options:
How do I set an IP address on a Juniper SRX?
Select Configure>Interfaces>Ports and click the ge-0/0/1 interface to edit. Under 'IPv4 Address' tab check 'IPv4 Address/DHCP configuration' and make sure 'Enable address configuration' is selected. Add the IP address and prefix, by clicking the '+' icon i.e. 192.168. 120.2/24 and click OK.22 abr 2020
How do you set the L3 VLAN on a Juniper switch?
- Enable VLAN tagging: [edit interfaces interface-name ] user@switch# set vlan-tagging.
- Bind each VLAN ID to a logical interface: [edit interfaces interface-name ] user@switch# set unit logical-unit-number vlan-id vlan-id-number.
How do I create a Layer 3 VLAN?
- Navigate to the Distribution Switch's details page from Monitor > Switches.
- Click Initialize layer 3 under the Status section.
- Enter the following settings: Name: Uplink. Subnet: 192.168. 128.0/24. Interface IP: 192.168. 128.1. VLAN: 20. ...
- Click Save.