If you are measuring you need the diameter of the center pin for the (ID) and the inner diameter of the port (OD). ID an OD measurements for both the female and male connector must match to connect properly.30 nov 2020
Can I use any 9v adapter?
– Yes, they are likely interchangeable even though voltage is not the same. This is because the voltage difference is within specs, and I am GUESSING you could go even higher or lower in voltage.17 jun 2021
How do I know if my charger is compatible?
Check the rating on it. Standard smartphones use 5 V chargers at about 1.5 A output. Laptops use a 19 V charger at 3.9 to 4 A output. If the charger you have with you has a compatible connector type with your device and matches the standard rating, you're good to go!
What is DC input for?
DC Input or Low Voltage LED drivers take DC voltage from a battery or switching power supply and output a constant current so as to keep the LED safe.
Can I use 9V AC for 9V DC?
The answer to your question is yes, it can.29 may 2014
What is 9V 1A adapter?
9V-1A AC/DC Power Adapter with Cable. With this product, you earn 1 loyalty point(s). This is a high-quality AC/DC adapter, it has over hot protection and short circuit protection. This is a high-quality AC/DC adapter, it has over hot protection and short circuit protection.
Can I use 12V 1A for 9V 1A?
yes you can but make sure the plus and minus is correct, usually inside of plug is plus and outside is minus, usually router has voltage stabilisation stages inside it already so 9v to 12v wont be big problem.
Can I use 12V adapter for 9V keyboard?
You can't use a 12V adapter to power a 9V guitar pedal.
Can I use 12V adapter for 9V router?
You cannot use that adapter because it is outputting more voltage than the original (12v vs. 9v). This has a likely chance of burning out one or more of the components within the router. ... The output voltages must be identical.28 ene 2013
Can you use a 12V adapter for a 13v device?
'12v' is often 'automotive' devices- in which case they are very tolerant of fairly wide voltage swings (basically from 10.8v to 14.4v is commonly seen in an automobile) so they will happily take a 13v supply without issue, as long as it can supply the amps- in this case device pulls 3a, supply can give 7a, so that's ...