Clean the screens in the water mixing valve and the filter screens located at the faucet end of the fill hoses. Unplug the machine for 15 seconds to clear this code. The washer has not filled to the proper water level. No or very little change in water level has been sensed within 5 minutes of the current fill.2021-04-01
Is there a reset button on a washing machine?
Most newer washing machines come with a reset feature that allows you to restart the washer after it experiences an error code or fault. ... Some machines have a button you push to reset its motor. On a machine without a reset button, unplugging the washer and then plugging it back in often serves as the means to reset it.2018-12-29
How do you force a Speed Queen washer?
- Step 1: Turn off the power and lay towels on the floor. ...
- Step 2: Locate the drain hose pipe at the back of your speed queen washing machine. ...
- Step 3: Drain the water. ...
- Step 4: Check for drainage hose clog and drain pump clog. ...
- Step 5: Consult a pro.
Why is my Speed Queen washer not starting?
Your Speed Queen washer won't start if the lid is raised. Lower the lid, and pull out the timer knob. Push the power cord snugly into an electrical outlet, and do not use an extension cord or adapter. ... If the washer still won't start, examine the lid switch and replace it if it's burned out.2019-03-15
How do I clear the error on my Speed Queen washer?
Make sure hot and cold water faucets are turned on. Make sure that the fill hoses are not kinked or twisted. Clean the screens in the water mixing valve and the filter screens located at the faucet end of the fill hoses. Unplug the machine for 15 seconds to clear this code.2021-04-01
Can you hard reset a washing machine?
To reset your washing machine, unplug it from the power outlet. Then, plug the washer cord back into the wall. Finally, open and close the washing machine door six times to send the reset signal to the system components.
How do I reset my washing machine program?
To reset your washing machine, unplug it from the power outlet. Then, plug the washer cord back into the wall. Finally, open and close the washing machine door six times to send the reset signal to the system components.