How do you add another collar to PetSafe stay and play?
How do you add another collar to PetSafe stay and play?
Place the receiver collar on your pet's neck or simply hold the collar near enough for your pet to hear the beeping of the collar during training. Put a separate non-metallic collar on your pet's neck ABOVE the receiver collar and attach a lead. Be sure the extra collar does not put pressure on the contact points.
How do you program a second PetSafe collar?
Use the lower gray button on the remote to set the display to d, found below level 1. Press the red button on the remote. This will program the remote to two dog mode and the static stimulation level will begin to flash. Use the grey buttons to select the level for and press the red button to lock the level.
Do all PetSafe collars work together?
The collars between these two types of systems are not interchangeable. Check your collar compatibility before purchasing an additional replacement collar.
How do I extend the range on my PetSafe wireless fence?
It Is Simple To Expand The Containment Area With The Purchase Of Additional Transmitters By Overlapping The Boundaries. You Can Use Another Wireless Transmitter With Overlapping Boundaries Of At Least 5-10 Feet To Increase The Size Of The Pet Area.
How do I reset my PetSafe collar?
Make sure the collar is powered on. Press and hold the button on the collar until a beep is heard and the light flashes green to turn the collar on. Press and hold the power button for 10 seconds to reset the collar. The light turns red and the collar turns off.
Why is my electric dog collar not working?
Make sure your battery is charged in both the collar and the transmitter. Low battery charge can make for inconsistent functioning. Make sure both pieces are turned on and that the unit is properly synced so that the collar is receiving a signal from the transmitter.6 Aug 2018
How do I know if my PetSafe wireless collar is working?
Use the test light tool or a coin to remove the battery from the collar. Lift the metal tab or spring gently to ensure the battery will firmly touch the tab when installed. Press and hold mode button on collar for 20 seconds. The light may come on and fade out.
Can you add another collar to PetSafe wireless?
Can I use more than one receiver collar on the system? Yes. There is no limit to the number of pets you can contain with the containment system. It's as simple as purchasing an additional (compatible) receiver collar for each pet.
Can I use a different collar for Invisible Fence?
The short answer is yes, many dog fence collar receivers are interchangeable.
How do I connect another PetSafe collar?
https://www.youtube.com/watch?v=hGsniYEn4d4
Can you replace a PetSafe collar?
Replacement 3/4-inch or 1-inch strap for PetSafe in-ground and wireless fence receiver collars. Simply remove the receiver unit from your pet's old receiver collar and place it on the new collar strap. Strap has 2 holes to fit most fence or remote trainer receivers with 2 contact points only.
How do I set the intensity on my PetSafe collar?
https://www.youtube.com/watch?v=rzvBx7PsQbM
How do I know if my pet safe collar is working?
Hold the collar probes against the wire on the test light tool. The collar will test all 15 stimulation levels, causing the tool to flash at each level. Important: The test light tool will have a dim flash when testing low levels. If a flash is not seen, hold the tool on the collar until higher levels are being tested.
Why is my PetSafe collar beeping but not shocking?
Position the test light tool on the collar probes and look for the light to illuminate. The highest the correction level on the collar the brighter the light will shine. If the collar beeps or the test light tool illuminates, the battery and collar are working. If not, replace the battery.4 Feb 2021