- Start the vehicle from a cold start.
- Let the engine run on idle.
- Accelerate to 55 mph.
- Hold a steady speed of 55 mph for 3 minutes.
- Let go of the accelerator and coast until the vehicle hits 20mph.
- Accelerate again until 60 mph.
- Hold steady for 5 minutes at 60mph for 5 minutes.
How long does it take OBD monitors to be ready?
About one week of combined city and highway driving is usually enough to allow the monitors to reach complete status.
How long is a drive cycle?
Preparation for it will take eight hours but, all in all, a basic drive cycle test should take around 30 minutes to complete, with about 20 minutes of actual driving.3 Aug 2019
What does a drive cycle include?
A driving cycle is a series of data points representing the speed of a vehicle versus time. Driving cycles are produced by different countries and organizations to assess the performance of vehicles in various ways, as for instance fuel consumption, electric vehicle autonomy and polluting emissions.
How many drive cycles does it take to turn off a mil?
two drive cycles
How long does it take to complete a full drive cycle?
How Long does it Take to Complete a Drive Cycle. Preparation for it will take eight hours but, all in all, a basic drive cycle test should take around 30 minutes to complete, with about 20 minutes of actual driving. Understanding your vehicle's overall health can help you ensure it drives smooth and lasts long.3 Aug 2019
How do you know when obd2 is ready?
- Turn the ignition key to the “on” position for 15 seconds without cranking the engine.
- If the “Service Engine Soon” light blinks eight times, one or more readiness monitors are incomplete.
How do you complete a drive cycle?
15 minutes of steady driving on an expressway/highway followed by 20 minutes of stop-and-go driving with at least four 30-second idle periods. Allow the vehicle to sit for at least eight hours without starting the engine. Then, start the engine and complete the above driving cycle.