Single use jig, cuts standard left and right hand joints, corner joints and peninsular joints in worktops up to 900mm width. • Enables recess to be cut for worktop joint clamps. • Use with a router and guide bush with 30mm outer diameter. • Made from laminated fibre board. • Includes aligning pins and instructions.
How do you use a kitchen jig?
https://www.youtube.com/watch?v=HzJza9Kt9vY
How do you work a Transtool worktop jig?
Place worktop face down with the postformed edge towards you. Place three location pins in the holes marked Z. Place the jig making sure all three pins are pushed firmly against the edge of the worktop. Secure the jig with clamps.
How do you cut worktops with a jig?
https://www.youtube.com/watch?v=Ux3EZhhYdZo
How do you cut a laminate worktop with a router?
https://www.youtube.com/watch?v=9LZJF5GZOwo
Do you router worktops upside down?
You don't need to turn the worktop upside down before cutting it. Always start the saw away from the material and once running at full speed and starting from the front edge of the worktop cutting towards the back slowly cut the worktop.
What router bit to cut worktops?
This good quality 1/2" TCT (Tungsten Carbide Tipped) router cutter can be used to cut through solid wood worktops with ease - when using a worktop jig and 1/2" router - and comes with a twin flute that allows for smooth and efficient cutting.
How do you cut a worktop without a jig?
https://www.youtube.com/watch?v=_JMpAKMUpmc
How do you cut a worktop by hand?
- Use a handsaw with 10 to 12 teeth per 25mm.
- Have the good side facing up.
- Use masking tape to cover the area you saw.
- Mark your measurements on the masking tape.
- Start cutting on the front profiled edge (the curved detail), not the back with the raw edge.