Leave the electrical power completely disconnected for 5 minutes. This will sometimes reset a control board that is stuck due to a power surge or glitch encountered through the electrical lines. Plug the dryer back in to see if the control will operate properly.May 15, 2009
Why does my Kenmore Elite dryer not start?
Several things could keep your electric dryer from operating normally, including a blown thermal fuse, a bad door switch, a broken start switch or an issue with your power supply. ... You'll find these troubleshooting tips helpful whether you have a Whirlpool, Maytag, Frigidaire or Kenmore dryer that won't start.
How do you fix a Kenmore dryer that won't start?
https://www.youtube.com/watch?v=jX-AI3jXzL4
How do you run a diagnostic on a Kenmore Elite dryer?
https://www.youtube.com/watch?v=DSBRJeWkt8w
Why is my Kenmore Elite dryer not turning on?
Several things could keep your electric dryer from operating normally, including a blown thermal fuse, a bad door switch, a broken start switch or an issue with your power supply. ... You'll find these troubleshooting tips helpful whether you have a Whirlpool, Maytag, Frigidaire or Kenmore dryer that won't start.
Why is my Kenmore Elite dryer not drying my clothes?
If the vent is clogged or partially clogged, it will restrict the airflow through the dryer, substantially increasing the drying time. To ensure proper dryer performance, you should clean your dryer's venting system at least once per year. ... If the air flow is weak, check the blower wheel for obstructions.
Can a dryer just stop working?
Overheating is a serious concern, and to combat it, dryers have thermal fuses. ... A faulty or broken thermostat can make a dryer stop working. Replacing the fuse or the thermostat will allow the dryer to work again. A blown thermal fuse from overheating indicates an additional problem, such as improper ventilation.
How do I know if my dryer fuse is blown?
- Unplug your dryer and ensure it is no longer connected to the gas or electric.
- Locate the thermal fuse, as above.
- Disconnect the thermal fuse from the wires.
- Test the fuse with a multimeter.
- If the needle on your multimeter does not move, your thermal fuse is blow.