How much does it cost to install vinyl siding per square foot?

100 square feet is equal to a square of vinyl siding.100 square feet is ten feet by 10 feet.There are many ways to look at 1 sq of vinyl siding.For example, if you divide 50 by 4 and 25 by 100, you get 100 sq ft.

This calculator can be used to calculate the number of siding squares you need.A square of siding is called Area.Since house siding is often measured in feet and inches, this calculator allows you to enter either feet or inches.

That depends.To find out how many squares are in one box, check with the vinyl siding manufacturer.

If your calculation is 58 squares of siding, you would need 29 boxes of vinyl siding.If you are calculating for vinyl shake siding which is 1/3 of a square per box, your calculations will be different.

It is very important to calculate for waste.Depending on the project, some contractors calculate up to 30% on top of the raw exterior square footage.When we were a contracting company, we used to get our waste down between 5% and 10%, but we had to plan our cuts and reuse our cut-offs.Depending on the project, most skilled vinyl siding installers will need to calculate between 15% and 20%.Your results may be different.There is a lot of skill involved in bidding and installing vinyl siding.Proper planning will save you a lot of headaches in the long run if you take your time.

We have an entire national network of pre-screened contractors who would be happy to professionally measure your home and give you expert advice, just go to our free, No Obligation Vinyl Siding Estimates page.For comparison purposes and to know your home’s exterior square feet, always get at least 3 to 4 siding estimates.It’s important to have a good experience with getting new house siding.