How much energy does my water heater use?

As important as having water running in your home is having a water heater.There are some things you would need hot water for if you didn’t have a water heater in your home.

To heat water above its initial temperature, an energy source has to be used.Kettles, pots, and coppers were used for water heating in the olden days.They don’t give a continuous supply of heated water at a preset temperature.If type of ez_fad_position is ‘undefined’.

Water heaters that use fuels and supply heated water at a preset temperature are new inventions thanks to technology.The gas water heater has helped put an end to the practice of heating water in batches.

Most gas water heaters don’t use electricity.Many of them rely on a small amount of electricity to light their igniter.A minimal amount of electricity is needed to start the gas heater.

If this post contains affiliate links, you will be taken to online retailers that sell products and services.I may make money if you click on one and buy something.See my Disclosure for more information.

The transfer of heat through a fluid is referred to asconvection by the law of physics.

The differences in gas water heaters are caused by the fact that they can be designed with a tank or be tankless.

Gas water heaters with tanks are less expensive.

In the case of a gas water heater that uses a tank, the sealed container is designed so that the cold water goes into the tank through a supply line while the gas burner is underneath it.

Cold water is supplied into the tank by the cold water supply line.The gas burner helps warm the water at the bottom of the tank as the supply goes on.

The water in the tank would start rising if a certain level of hotness was achieved.

The hot water at the top of the tank gets put into the supply line so that it can be used wherever it is needed.

The hot water discharge pipe is not as long as the cold water supply pipe because it reaches for the hottest water at the top of the tank.

There is a thermostat that you can use to monitor the temperature of the water in the tank.

The burner is turned on and off by the thermostat.You can set the water temperature with this thermostat.

If type of ez_fad_position is ‘undefined’

A heat exchanger is a device that transfers heat from one place to another.

When you turn on your faucet, the incoming flow of water causes the heat exchanger to move around, heating the water to your preset temperature.

Some gas water heaters rely on less electricity than electric ones, but they do not rely solely on electricity to operate.

Some models use electricity while others use traditional means to light their pilot light.Electric power can be used to light the igniter in gas water heaters.

An electric current can be used to sense the flow of water and send heat from the gas burner to the water.If the type of ez_fad_position is ‘undefined’.

There are other ways to power your gas water heater that don’t require an electric supply.

You can use a computer battery backup to power the computer component of your water heater, or you can install another type of water heating system that doesn’t use electricity.

It’s clear that a lot of gas water heaters need electricity to work.

If you were to use a water heater that relied solely on electricity, you wouldn’t have to plug them like other water heaters, and you would save a lot on your electricity bills.

The sole reason for electricity is to start the gas water.