Smoking a pipe can be relaxing.Many beginning smokers pack their pipes too tight.You need to learn how to pack and light a pipe for a pleasant smoking experience.The pipe is packed
Step 1: Pick your fire.
You can use a wooden match or pipe lighter.The taste of tobacco should not be altered by pipe lighters.If you use a match, burn it for a few seconds to get the sulfur off.Lighters that aren't specifically designed for tobacco pipes should be avoided.The butane from the lighter is said to affect the flavor of the tobacco.A wooden match is needed against the emery strip.Before applying sulfur to the pipe, allow it to burn off the tip.Lighter fluid won't have a taste of a wooden match.
Step 2: There is a false light.
Don't light it completely yet, Char the top of the tobacco.The flame should be held just above the tobacco.Use half a dozen puffs to draw your breath.All of the tobacco can be reached by moving the flame in a circle.The purpose of the "charring light" is to burn the tobacco slightly, but not completely.Don't breathe in the smoke.Pipe tobacco is stronger and has more flavor than cigarettes.
Step 3: Don't stop smoking and puffing.
The true light is when the pipe is evenly lit.To make sure the pipe stays lit, keep puffing.Once it is properly burning, the bowl should stay lit for at least 5-15 minutes.The tobacco has air flowing through it.If you don't want to inhale so much, try exhaling gently.A small amount of smoke should come out of the bowl when the air stokes the pipe fire.
Step 4: If it's necessary, light the pipe.
Over the course of the smoking session, you may need to relight your pipe several times.The same motion is used with your match.When the light goes out, lightly remove the charred top from the tobacco.The ash removal will allow the pipe to burn more evenly.
Step 5: Start with an empty pipe.
Run a pipe cleaner through the stem to clean the pipe.After turning the pipe over, dump the debris into an ashtray.To clear the pipe completely, blow through it.
Step 6: Pinch some tobacco.
It should be spread on a piece of paper.Check that it is not moist by breaking up clumps.If it is moist, spread it across the paper to dry it out.
Step 7: The bowl should be packed.
Take the strands of tobacco out of the bowl.Continue until it reaches the top of the bowl.
Step 8: The bowl of the pipe should be tampered with.
There are online retailers that sell tobacco products.When you hit the tobacco, gently press.Don't touch the tobacco with your hands.The tobacco can be clumped together by the finger oils.
Step 9: The level of tobacco should be checked.
If your pipe is straight, you should fill half the bowl.It should be at least two-thirds full if it has graduated sides.
Step 10: You should put the pipe in your mouth.
Take your breath out.The bowl is too tight if it is hard to get air through.When it is packed, the tobacco should be soft and springy.
Step 11: When the bowl is slightly overfull, add more tobacco in small strands.
You did it the first time.Use gentle pressure.
Step 12: You can draw on the pipe again.
You might need to draw more breath.The air should still come through the pipe.The bowl is packed too tight if air doesn't come through.Start over again.
Step 13: Drop more strands into the bowl.
Tamp is down gently.The bowl needs to be full and ready to light up.
Step 14: You can buy a pipe.
Purchase a cheap corncob pipe if you're just starting.Smoking marijuana and other non-tobacco plants can be done with glass pipes.
Step 15: Smoke in a respectful manner.
Like cigarettes, pipe tobacco can cause indoor air pollution.Light the pipe from the entrance of the public space.If you can.Pack your pipe inside and bring it outside on a windy day.
Step 16: Take your time.
Enjoy the smoke.20 minutes is enough to smoke your first pipe.