If you live in a dry climate, swamp or evaporative coolers are a great way to cool off.Raising the humidity in your home is accomplished by swamp coolers.They work well in dry climates.If you want to use a swamp cooler, you have to pick the right one.As the weather warms, you can use it to cool your home.
Step 1: Pick between window, roof, and ground-mounted.
A window-mounted cooler is similar to an AC window unit.There are swamp coolers that can be installed on the roof or outside.It's easy to install a window unit.It will only cool a few rooms.It is more difficult to install a roof-mounted unit.You don't have to worry about your swamp cooler leaking through the roof if you have a ground-mounted version.It's easier to perform maintenance on this version.
Step 2: 20 to 40 air changes per hour can be created by a unit.
You need enough blowing power to cool your entire house with a cooling unit.The power in swamp coolers is measured in feet per minute.The required amount of changes per hour is 30.An air change is when all the air in your house is gone.Determine the volume of the house.To figure out the volume, divide your square footage by your ceiling height.Next, figure out how much time it takes.If you divide your volume by 2, it will give you enough power to get 30 changes per hour.
Step 3: You can choose from 1,000 ton.
If you're replacing an existing air conditioner with a swamp cooler, you should choose a lower CFM.You choose a less powerful option because the duct work won't be large enough for a swamp color.Pick 1,000 for each air conditioning ton.An air conditioning ton is a measurement.The amount of heat the air conditioner can remove in one hour is referred to.
Step 4: A filter can be added to reduce dust.
If you are worried about allergies, a unit with an air filter can help.If you have an allergy you may get it from the outside.
Step 5: The cooler should be operating when the dew point is under 55 F.
When the humidity outside is low, swamp coolers work best.On most weather websites and apps, you can see the dew point.The temperature at which the water in the air is being evaporated is called the dew point.swamp coolers work by cooling the room down with water in the air.The lower the dew point, the cooler you can be.It's possible to cool down the air to 20 degrees above the temperature in your home.You can use a calculator to calculate the dew point, like this one: http://www.dpcalc.org/.You have to know the temperature and humidity.
Step 6: You can let the air out by opening a window.
If you want the swamp cooler to work, you need to let air out at the same rate.If humidity builds up in your house, it will make it seem warmer than it really is.It helps your swamp cooler work better if you open the windows.The unit's cooling capacity is determined by the amount of open window space per 1,000 cfm.You don't want to open them too far away from each other.If your attic has ventilation, you can install grills to the attic.
Step 7: You don't want the windows to be open.
Only open windows where you want the air to be cooler will pull the cold air that way.Keep the windows closed in areas you don't want to be warm.
Step 8: The fan option can be used when the weather is nice.
If the weather is nice outside, swamp coolers can be used as a house-wide fan.The vent-only option can be used to cool down your house.
Step 9: The speed can be changed to your preference.
swamp coolers can have more than one speed.The lower the speed, the cooler the home.Pick the one that's right for you.