Where is the model number on a Hampton Bay ceiling fan?

Where is the model number on a Hampton Bay ceiling fan?

On Hampton Bay ceiling fans, the product number is usually found on a sticker (usually silver) on top of the motor housing.

How do I find the model of my ceiling fan?

- Part guide or installation manual that came inside your ceiling fan box. - Outside of the box. - On the fan itself. Location depends on the type of fan: For Downrod-mount fans- ID sticker located on top of the motor housing (facing the ceiling of an installed fan).

Where is the serial number on a ceiling fan?

motor housing

What company makes Hampton Bay ceiling fans?

Home Depot

How do I reset my fan control?

To resync your ceiling fan remote, start by turning off your fan using the wall switch and then waiting for a few seconds. Different guides will tell you to wait anywhere from 10-30 seconds while the fan is off. After waiting, turn the fan back on again.

How do you reprogram a ceiling fan?

https://www.youtube.com/watch?v=f8OSWDAFPT4

Why did my ceiling fan suddenly stop working?

This could be because the circuit breaker has tripped or is off. Check your panel to confirm this. If the circuit breaker works fine, it could be a problem with loose wiring and connections. Your ceiling fan could also stop working due to internal defects namely shot ball bearings or an overheated motor.

Why is my ceiling fan not responding to the remote?

Perhaps the most common cause for a ceiling fan remotes not working is either a lack of batteries or dead batteries. ... If it doesn't, that's a good sign that it has a battery problem. Open the remote control battery cover. Make sure it has batteries and that they're in the correct position.

Do ceiling fan remote receivers go bad?

The remote receiver varies the voltage and current to change the fan motor speed. But ceiling fan remote control units can go bad too. Before you even think about tearing the fan apart to diagnose a problem, replace the batteries in the transmitter first.

How can you tell if a ceiling fan capacitor is bad?

The capacitor is usually a black box inside the switch housing of the fan. If the case appears burnt or melted in any way, that is also the sign of a bad capacitor and it should be replaced. Keep in mind that there may be other components in the circuit with the defective capacitor.

How do you clean a Hampton Bay ceiling fan?

https://www.youtube.com/watch?v=eGKM0ldrlEM

How do you remove a ceiling fan cover?

https://www.youtube.com/watch?v=klR1_dUAkpo