The most likely cause of a stereo not powering up is a blown fuse. Other causes can be a short in the wiring or other wiring problems. Cars are unforgiving environments for electronics, and vibration, heat and dust can all cause premature failure. Vibration can cause wiring to become loose.
What would cause a car radio to not turn on?
Common reasons for this to happen: Blown Fuse: One of the most common reasons for a car radio to stop working is a blown fuse. If the radio itself will not turn on, chances are good that there's one or more blown fuses causing the problem.
Where is the reset button on my Kenwood radio?
The reset button is a small triangle button that is usually lit up too; hence, it is easy to identify. You can find it at the top left corner of your stereo. Hold on to the reset button for five seconds for a soft reset.2021-08-21
How do I fix my Kenwood radio when it wont turn on?
If the radio will not turn on, first check the fuse located on the back of the radio. If the fuse is burnt, replace with a fuse of the same amperage rating. The guide to replacing the fuse can be found here.
What do you do if your stereo wont turn on?
- Common Car Radio Problems.
- Check the Unit for Protect Mode.
- Check the Fuses.
- Check the Pigtail Connector.
- Check for Power at Head Unit.
- Check for Ground at Head Unit.
- Bench Test the Head Unit.
How do I get my Kenwood radio to work?
- Select the Tuner source. Refer to .
- Press and hold the [AUDIO] button. Enter the Function setting mode.
- Use the [Control knob] to select "SETTINGS". ...
- Use the [Control knob] to select a Tuner setting item. ...
- Use the [Control knob] to select a setting.