With the vehicle off, turn the key to the “on” position, but don't start the car. Hold the TPMS reset button until the tire pressure light blinks three times, then release it. Start the car and wait 20 minutes for the sensor to refresh. The TPMS reset button is usually located beneath the steering wheel.
How do you turn off the service tire monitor light on a 2007 Chevy Silverado?
With the engine off, turn the ignition key to the RUN position. This will put the vehicle into reset mode and alert you with two clicks of the horn before the tire pressure monitor service light begins to flash. To reset the truck, turn the headlight switch from ON to OFF four times within three to four seconds.
How do you reset the tire pressure sensor on a 2011 Chevy Silverado?
https://www.youtube.com/watch?v=7Zv1opwr-AI
How do you reset the service tire monitor system on a 2009 Chevy Silverado?
Activate each sensor by removing the valve cap from the tire and then increase or decrease the pressure until the horn chirps. Start with the driver's side front tire and move clockwise around the vehicle. Turn the ignition off after You're done with the final tire and message in the display should disappear.
How much does it cost to service tire monitor?
The service kit costs $5-$10 per wheel on most vehicles. A special TPMS tool and additional time are also needed to check and reset the sensor system. In the event pressure sensors need to be replaced, the cost ranges from $50-$250 each depending on vehicle type.22 ago 2016
What does it mean when it says service tire monitoring system?
What is a Service Tire Monitor System? Whenever your car says service tire monitor system, this means that more than likely you have a bad tire pressure monitor sensor (TPMS). Don't worry this light isn't going to hurt your car at all. This warning is just letting you know something is wrong with the TPMS.