How to bleed gas lines for a gas fireplace is on HunkerOwners Manual.
Like woodburning fireplaces, gas fireplaces have a season.It is easy to turn on a gas fireplace.If it's the beginning of the cold season or you haven't used your gas fireplace in two months or more, you'll want to bleed the lines before starting the fireplace.
Air holes can occur in the lines while your fireplace is not being used.It is not difficult to bleed pilot gas lines.Make sure you follow the directions.
Make sure you are in aventilated room and that there are no open flames nearby.The gas line to your fireplace has a shut-off valve.Turn the valve assembly to the gas line.The pilot assembly can be found either in the bottom of the fireplace box or behind the logs.
The igniter switch can be found.It is either red or black.Push the igniter button.The pilot assembly should have a blue spark.A pilot light needs to light and remain lit to generate heat.To keep the pilot light on, you'll need to make sure there's no air in the gas line.
A pilot light is started by turning on the gas.A spark is used to light the gas.
The gas valve control knob is where you'll want to locate it.When you see the word "Pilot" or "Ignition" in the "On" position, push it in.It should press inward a quarter of an inch when held in this position.
Press the igniter button repeatedly when pressing the valve control knob.As the gas starts to flow, it could take anywhere from one to 10 minutes to bleed air out of the lines.
Continue to press the valve knob inward for 30 seconds after the pilot is lit.The valve should be turned to "On" when the pilot light is on.Start the procedure again if the pilot light goes out.As long as you use your fireplace regularly, you should be able to switch on and off easily when the pilot light stays on.
The spark igniter could be the problem if gas isn't coming out of the pilot.The igniter and the safety pilot system need to be clear of debris.The combination valve and a metal probe that controls the gas valve are included.If the pilot lights but does not stay on, try blowing compressed air into the area.
It's important that the fuel to air mixture in your fireplace is correct.The air vent needs to be kept free of debris.You should be able to enjoy your gas fireplace for the season once this is taken care of.
There are risks to using natural gas from a gas line or propane source.As long as you follow instructions, these are minimized.The first thing to do is keep your user manual for any item in your house that uses gas.If your fireplace is flooded, it's best to call in a heating or gas contractor to make sure the gas line is safe to use.
There is a leak if you smell gas.mercaptan is added to natural gas.The smell of gas is similar to rotten eggs.If you smell gas, get everyone out of the house.If the windows are open, do not stop to open them.If you don't know the source of your gas, call your energy provider.