How to create a Curved Paver Walkway,Designing Curved Brick Walkways, and eHow to build Forms for a Curving Concrete Sidewalk are all on Do ItYourself.com.

The walkways are very stylish.brick or concrete are preferred by many house owners.These have their own advantages, but curved paver walkways are an economical alternative.These come in different colors and sizes so you can mix and match your ideas into a grandiose walkway.If you complete the job yourself, you can make the decision to have a curved walkway more cost-effective.

The design of the walkway can be decided where you want to install it.If you want the walkway for sitting or patio areas, a circular design is best since it gives an image of being in the spotlight.

You can add a cobblestone touch.You'll need stones for this.Once the job is done, you will be compensated for that extra character on your walkway.

You can choose a curved path along with a meandering one.The walkway can add direction in movement.Garden paths are best suited by this design.You can use different colors to create a mosaic.

Come up with a design of your own if your mind is a computer of imagination.The procedure will not change.The best-suited design will allow you to change the placement of the pavers.

To make the curved walkway, mark the area where you want to make it.You can use any marker, but a spray-paint will make it easier to make a thick outline.The walkway should be large, curved or long according to the idea.You can use the distance to figure out how much you'll need for this task.

You need to dig a depth of about six inches using a shovel.The walkway needs a two-inch pitch for every ten feet.Once you are done digging, you need to use a plate compactor.

Adding three inches of gravel is the next step.The plate compactor needs to be used.You need to repeat the above steps again, but this time the gravel needs to be covered with sand.

The edging of your walkways landscape needs to be set up according to the manufacturer's directions.The path will be visible as a result of this.

Carefully place each paver on the sand.Make sure that each one is leveled the same way.You can make all the designs you want here.Some pavers might have to be trimmed when you reach the edges.This can be accomplished with a concrete saw.Once the path is complete, you can use your broom to clean the walkway.